Pre-wall installation system for building into solid walls with reinforcing fibreglass mesh

AM1115P/1000 Renovmodul Slim

Product details

Water connection from the back or top via mounting holes	G1/2 "
Functional range of water pressure	0,05 – 1,6 MPa
Recommended range of water pressure	0,3 – 0,5 MPa
Factory setting of large flush	6 l
Factory setting of small flush	3 l
Hygienic reserve	3 l
Water volume in the cistern	9 l
Load test	400 kg

For wall-hung WC
For walling in and around the bearing wall - wet process, installation depth only 86 mm
Suitable for reconstruction
For installation of wall-hung WC pans with a connecting pitch of 180 mm or 230 mm

Sliding rail holder for the waste connector can be set to eight positions between 0–93 mm
Angle valve with the ability to connect to the Mepla piping system
This technical solution allows anchoring to an uneven surface of the back wall where a cut out was made, in the range of 50 mm
Galvanized support structure with four hinged brackets for easy installation
The construction of polystyrene insulation prevents condensation forming on the surface of the tank and dampens the vibrations from the tank into the building structure
Dual flush independently adjustable with hygienic reserve
Compatible with all ALCA flush plates
Maintenance work without using any tools
Water supply from rear / top / left / right
Removable piece of polystyrene allows for easy access during installation
The cistern is made of one piece, thus ensuring 100% impermeability
The service opening cover simplifies assembly and prevents the penetration of moisture and impurities
Mounting height 1070 mm
Installation depth adjustable from 20–60 mm
Installation depth 86 mm, with a 125 mm waste elbow
Material of the load bearing structure: galvanized metal

Cistern with fill and flush valve
Galvanized frame including supporting structure
Threading 1/2" for water connection with an integrated angle valve 1/2"–3/8"
Fixation set: screw Ø8×60 – 4 pcs, dowel Ø12 – 4 pcs
Fixation material for fixing the WC pan: threaded rod M12 – 2 pcs, washers – 4 pcs , cover – 2 pcs, nut – 2 pcs, thread protector – 2 pcs
Waste elbow HT 90/110 polypropylene
Inlet seal, PP outlet, wrapping seal
Drainage seal, PP connector, connector seal
End-caps set for protecting the connecting holes during installation of the system
The 2 piece cover of the service opening is simply adjustable
Reinforcing fibreglass mesh